Forum Replies Created
OK, I’m back @ home and just find how to change the bk_release command. It works ! yay.
I’ve tested some features… and now, I got a new question:
I want to format disk. For that, I need to hold REC and then press Rev play.
But, the REC command seems to be “auto released” … so, when I tried a task with
0 – Record
1 – bk_play_rec
2 – bk_release
It doesn’t work…
any idea ??
I tried to record some videos, too… but it’s supposed to tell me there’s nothing connected, if I didn’t connect a proper video source to the input (of course, I set the bonsai drive as requested… for instance, CVBS if it’s a single BNC for video connection)
but when I hit the REC command, it sends me to Menu 092, giving disk info… (that’s why I want to format the Bonsai)
again, thanks for your time and kindness…
I’m out for the next two weeks (work, work… you know how it is..)
but I’ll sure try asap !!! and, of course, will keep you posted.
thanks again for your time and kindness.
The img doesn’t seems to work, so I attached the picture here…
As requested, the cable pinout
SubD9 for Mac Rs-422″ />
I unplugged the RS-422 cable from the bonsai drive, it keeps running thru menus… I had to electrically unplug it.
I re-plug and tried another cmd: bk_menu … it does work but it seems it’s the same: it keeps runnin… and so, I can’t send any other bk_ commands…
I’ve noticed that every cmd got the ACK msg… but the bk_release got a timeout msg….
woops, reply to myself… I’ve forgot to save the baud change… it was 9800 ..
ok, another pb now: I’ve sent the bk_play cmd. the bonsai drive start to browse thru all menus like crazy… so, I sent the bk_release right after that…. but nothing change ? the bonsai drive keep browsing thru menus…??
I can make it play, stop, etc.. al transsport fonctions are fine.
thanks both for your time…!
I got the keyspan USA-28X on my mac and it’s seen (finding a driver for 10.11 wasn’t easy, but it’s done)… after a moment, I get how to make it seen by V-Control (configure/channels, then ask to refresh while in serial settings)
but I got no idea which settings I am supposed to send ??
I’ve tried the settings
Baudrate : 38400
DataBits : 8
Parity : o
StopBits : 1
then added the 28Xtest as channel to my Bonsai Drive_1 device, , then I selected bk_play, Run CMD then bk_release, RUN CMD… but no result at all
What do I do wrong ?
OK. Thanks for reply !!! (;
I got a USB <> Mini Din 9 serial , from Keyspan , the USA-28X, and a cable MiniDin 9 > Sub-d 9 Rs422… basically, it was used to control a Beta or DVCam (or else) using RS-422 on an old ProTools 6 TDM workstation…
I think it can do the trick…
in fact, I got my bonsai drive without the original remote controller… and so, I can configure it properly… can I do that with V-Control ? (access the menu, format the disk, change the settings… these things I can’t do on a BVE…)
damn.. didn’t mean “I can’t configure” but “I can’t figure” … -___-‘