Hello to Group,
I am testing V Control software the last few days and i like it very much. Up to now i manage to control a Kramer router VS-1616SDI that i had available sitting in a corner.
After that and when i will feel more comfortable using the software i am planning to write mu own device drivers mainly for controlling Blustream devices.
I am looking for a way to set V-Control in run mode either when the software start or if possible by a button through gui designer.
Any ideas how to do that?
Autostart Task: launch the selected task if the Autostart File was loaded. Note: Only if an Autostart Task is selected, V-Control switches to Run Mode automatically. If you don’t need a task running at startup, but want to enter Run Mode automatically, create a task that does nothing and select it here. The Clear button removes the selection.