Using the Yamaha Rx-V1900 Driver

Home › Forums › V-Control General › Using the Yamaha Rx-V1900 Driver

Log In Register Lost Password
Viewing 3 posts - 16 through 18 (of 18 total)
1 2
  • Author
    Posts
  • September 6, 2016 at 14:17 #1283
    anika
    Participant

    Good idea, I will try asking them. Thanks!

    September 29, 2016 at 14:23 #1301
    anika
    Participant

    Solved!

    So, I tried Yamaha, who sent me an updated RS232 pdf, but unfortunatly the update did not have anything to do with power settings.

    However, I solved it today by accident. Turns out, that the Ack-command wasn’t working for some reason. I don’t know why it wasn’t working – it was set as ack command in V-Control, but when I used a showmessage(ioresult) in the Ack Command it suddenly started working.

    I rewrote the Ack-Command to give me the required feedback. My current amp driver (which basically only contains Power On/Off) is attached to this post, in case anyone is interested.

    Attachments:
    1. RX-V1900_amp.dr3
    October 6, 2016 at 08:49 #1310
    Dierk Walter
    Keymaster

    Thanks for the driver

  • Author
    Posts
Log In Register Lost Password
Viewing 3 posts - 16 through 18 (of 18 total)
1 2
  • You must be logged in to reply to this topic.