[DRIVER][V4]Lightware 220pro TX & RX Module inkl. Live Update

Home Forums V-Control Show Case [DRIVER][V4]Lightware 220pro TX & RX Module inkl. Live Update

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2251
    JonasStade
    Participant

    Hello everyone,

    I programmed three NEW drivers for VControl 4. If you know the Device, 220pro is a fiber optic HDMi transmitter with 2x inputs and 3x outputs on the receiver side. The device communication protocol is LW3.

    I wrote two versions. One is divided for TX and RX and has a Live Update function. This means, the device is constantly requested by VControl to get Port and Device Information. You can write a HTML Page and monitor all your fiber optic device incl. link speed (fiber quality) and if signal is availible on the port and if a cable is connected.

    If you don’t want traffic on the network between the Devices, you can also use the reduced TX/RX driver, which can only sends commands and don’t request the Device.

    greetz Jonas

    #2252
    JonasStade
    Participant

    Driver Upload didn’t wokr, this is another try

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.