Reply To: Script syntax and a subroutine

Home Forums V-Control General Script syntax and a subroutine Reply To: Script syntax and a subroutine

#673
Dierk
Participant

If I understand you right then you want to send two command strings within one command, is that right?

If so, you can build your first command. In the device editor you find a drop down box labeled “Next Command”. Here you can define the command that has to execute after the first command.
If the next Command should only be executed under a specific circumstance, you can also define the Next Comand in script.
The ImagePro_Network driver might be a good example. There is one Login Command that is separated in 3 commands, but the user only uses the first one.

Hint:
In the device Manager you’ll find a drop down box called “Next Command”. Here you can define a command that has to be executed after the current command. You can also define the Next Com,mand in the driver. as simple as

NextCommand="MyNextCommad"

All Commads that are executed by NextCommand use the Parameters (DP1,DP2, P1…P4) from the first initial command.

Hope that was not to confusing.

Scroll to top