Reply To: [DRIVER][V4] AnalogWay Aquilon

Home Forums V-Control Show Case [DRIVER][V4] AnalogWay Aquilon Reply To: [DRIVER][V4] AnalogWay Aquilon

#13081
JonasStade
Participant

hellooo,

first time using aquilon / livepremier system on a job with a little bit time, so I implemented the AWJ Protocol in a NEW Driver. With JSON Driver there are problems to read out data, because V-Control decides in the channels, if its POST or GET and you need POST for setting Values and GET to read out values. So This driver also uses device variable to setup layer for example. If you read the protocol manual you have to read out the layer state first so you can set the right target for the source. Its a bit complicated because to fill a layer you need 3 commands =>
Status_TBar – Reads out the data that you need
SetSourceToLayer – Uses the read out Data from Status_Tbar
Update_Layer – Updates all WEB RCS in the Network, its recommended to use, after you are done routing ALL you Layers!!

have fun with this 😉

Scroll to top